On-Off Switch - Peavey Messenger Pro Sub P Serie Manual De Instrucciones

The Peavey PRO™ Sub P active powered sub woofer can be used with the Pro™ 12P or Pro™ 15P, in sound
reinforcement and public address systems.
A typical signal source for the line-level inputs of the Peavey PRO™ Sub P would be a sound reinforcement mixing
console (mixer).
Rear Panel – Power Section
(1) FUSE
The unit is AC power line fuse protected from overloads and fault conditions with a T-type
fuse. This fuse is located within the cap of the fuse holder. If the fuse fails, the fuse must
be replaced with the same type and value in order to avoid damage to the
equipment and to prevent voiding the warranty. If the unit repeatedly blows fuses it
should be taken to a qualified service centre for repair.
(2) IEC POWER CORD CONNECTION
This receptacle is for the IEC line cord (supplied) that provides AC power to the unit.
Never break off the ground pin on any equipment. It is provided for your safety. To
prevent the risk of shock or fire hazard, always be sure that the mixer and all other
associated equipment is properly grounded.

(3) ON-OFF SWITCH

This rocker switch supplies AC power to the PRO™ Sub P when switched to the ON
position
All manuals and user guides at all-guides.com
APPLICATIONS