Declaration Of Conformity; Safety Regulations - Holmatro SCV 12 Manual

EN
To prevent errors of operation and ensure that the equipment works trouble-free, the user manuals must
always be available to the operator.
1.5 Application
This product is part of the equipment intended for lifting or forcing aside structural parts of vehicles,
ships, trains, aircraft or buildings.
This product is part of the equipment intended for use with compressed air such as Holmatro lifting
bags. The basic aim of this product is to control the air flow and provide safety valves.
Holmatro lifting bags are designed to be operated by compressed air.
The working pressure of the system is listed in the section Technical Specifications in this document.
1.6 Qualified personnel
The system may only be operated by people trained in its use. Always obey local legislation, safety and
environmental regulations. Repair work may only be performed by a Holmatro Certified Technician.
1.7 Guarantee
Refer to the general terms and conditions of sale for the guarantee conditions, available from your
Holmatro dealer on request.
Holmatro draws your attention to the fact that every guarantee on your piece of equipment or system
will lapse and that you must indemnify Holmatro against any possible product liability and responsibility
if:
• service and maintenance are not carried out strictly in accordance with the instructions, repairs are
not performed by a Holmatro Certified Technician or are performed without prior written consent;
• self-made changes, structural changes, deactivation of safety devices, injudicious adjustment of
hydraulic valves and faulty repairs have been carried out;
• non-genuine Holmatro parts or lubricants other than the types prescribed are used;
• the piece of equipment or the system is used injudiciously, through errors of operation, improperly,
negligently or not in accordance with its nature and/or purpose.
1.8

Declaration of Conformity

The equipment is CE certified. It means that the equipment complies with the essential requirements
concerning safety. The original Declaration of Conformity is supplied with the equipment.
The standards and directives that have been taken into consideration in the design are listed in the
section Technical Specifications in this document.
2

Safety regulations

2.1 Explanation of the symbols used in this manual
In this manual the symbols below are used to indicate possible dangers.
DANGER
Indicates an imminently hazardous situation which, if not avoided, will result in death or
serious injury.
WARNING
Indicates a potentially hazardous situation which, if not avoided, could result in death or
serious injury.
14
All manuals and user guides at all-guides.com
916.001.518_000 xCV 12