Safety Instructions - Oleo-Mac PW 125 C Manual Del Usuario

WARNING
• Use the following personal protection equipment (PPE):
Wear protective clothes.
Wear protective ear muffs.
Wear protective gloves.
• Wear protective gloves and a face shield during unpacking operations to avoid injury to the hands
and eyes.
• Parts of the packaging (plastic bags, staples, etc.) must be kept out of children's reach, as potential
sources of danger.
• The disposal of packaging parts must be carried out in accordance with the standards of the
country in which the machine is installed.
Plastic packaging must not be discarded in the environment.
• After having unpacked the machine, make sure it is intact. Also, check that the identification plate
and warning signs are present and legible.
If in doubt, do not use the machine and contact a
• The machine is not intended to be connected to the potable water mains.
If you want to connect the machine to the potable water mains, you must use a backflow
prevention device, in accordance with EN 60335-2-79 (purchasable at your retailer).
Operations such as water tank suctioning can be performed without backflow preventer..
• WARNING. Water that has flowed through the backflow preventer is considered to be non-potable.
• The electric supply connection shall be made by a qualified electrician and comply with IEC
60364-1.
It is recommended that the electric supply to this machine should include either a residual current
device that will interrupt the supply if the leakage current to earth exceeds 30 mA for 30 ms or a
device that will test the earth circuit.
• A
QUALIFIED ELECTRICIAN
- Check that the power supply system is in accordance with the data indicated on the identification
plate: the voltage should not vary by more than ± 5 %;
- If the power supply cable is not available and if the device is not to be connected in a fixed
manner to the power supply, fit a plug in compliance with the standard of the country in which
the machine is installed;
- Check that the power socket the machine is plugged into is fitted with a suitable fuse (the value
is indicated on the identification plate and on the Technical data chart).

SAFETY INSTRUCTIONS

Not following the instructions given below may
cause highly probable injury to persons or harm
to the environment
must carry out the following:
Wear a face schield.
Wear safety boots.
QUALIFIED TECHNICIAN
.
GB
17