Oleo-Mac PW 125 C Manual Del Usuario página 22

ADDITIONAL INSTRUCTIONS FOR HOT WATER FED MACHINES
• Some accessories may have a maximum operating temperature lower than the maximum
attainable by the machine: in these cases, it is necessary to limit the temperature by means of
the appropriate adjustment knob.
• Use
AUTOMOTIVE GAS OIL
• WARNING. Incorrect fuels shall not be used as they may prove hazardous.
• WARNING. For gas or oil-heated machines it is important to provide adequate ventilation and
make sure that the flue gases are properly discharged.
• WARNING. Ensure that any exhaust emissions are not in the vicinity of air intakes.
• Do not cover the exhaust gas outlet of the boiler.
• Never bend over the exhaust gas outlet and never touch it with the hands (danger of burns).
• When filling/topping up the fuel and detergent tanks, take care not to confuse the two: if this
should occur, do not use the machine and contact a
• When filling/topping up the fuel tank, take care not to spill liquid onto the machine. If this should
happen, wait for at least 24 hours before using the machine, so that the liquid that may have
penetrated inside the device has time to evaporate.
• For oil fired machines without a flame safety control: Do not leave the machine unattended during
operation.
• When the high-pressure water cleaner goes into
with the safety device and make sure that it is not inadvertently activated.
CAUTION
• See the table in paragraph
the supply water values of the: minimum flow-rate; maximum and minimum temperature;
maximum and minimum pressure (maximum priming depth): if in doubt, contact a
.
TECHNICIAN
• If priming a tank, it is advisable to fit a supplementary filter at the end of the suction pipe (contact
your dealer in this regard).
• Do not operate the machine:
- Without water supply;
- With brackish water or water containing impurities: if this should happen, run the cleaner for
a few minutes with clean water;
- For more than three minutes in by-pass (gun closed), if the Total Stop is not available or if cleaning
at a very low pressure so that the device does not activate (see the technical specifications table);
- If it is excessively noisy and/or there are significant water or oil dripping;
22
only.
PRECAUTIONS FOR CORRECT USE
If the indications below are ignored, there is a
strong possibility to damage the machine.
"TECHNICAL CHARACTERISTICS AND SPECIFICATIONS"
QUALIFIED TECHNICIAN
, the lever of the gun must be blocked
TOTAL STOP
.
and observe
QUALIFIED