Cleaning And Maintenance - Ferm AGM1052 Traducción Del Manual Original

EN
Mounting and removing the grinding disc
(fig. B)
2
Do not use the machine without the
guard.
Mounting
● Place the machine on a table with the guard
(4) facing upwards.
● Keep the spindle lock button (2) pressed and
remove the flange (7) using the flange key (8).
● Mount the grinding disc (9).
● Keep the spindle lock button (2) pressed and
mount the flange (7) using the flange key (8).
Removing
● Place the machine on a table with the guard
(4) facing upwards.
● Keep the spindle lock button (2) pressed and
remove the flange (7) using the flange key (8).
● Remove the grinding disc (9).
● Keep the spindle lock button (2) pressed and
mount the flange (7) using the flange key (8).
Mounting and removing the auxiliary grip
(fig. C)
Mounting
● Tighten the auxiliary grip (6) into one of the
mounting holes (13).
Removing
● Loosen the auxiliary grip (6) from the mounting
hole (13).
USE
Switching on and off (fig. A)
● To switch on the machine in continuous mode,
slide the on/off switch (1) in the direction of the
grinding disc.
● To switch off the machine, press the lower part
of the on/off switch (1).
Hints for optimum use
● Clamp the workpiece. Use a clamping device
for small workpieces.
● Draw a line to define the direction in which to
guide the grinding disc.
● Hold the machine with both hands.
● Switch on the machine.
● Wait until the machine has reached full speed.
● Place the grinding disc on the workpiece.
● Slowly move the machine along the pre-drawn
line, firmly pressing the grinding disc against
the workpiece.
● Do not apply too much pressure on the
8
All manuals and user guides at all-guides.com
● Switch off the machine and wait for the

CLEANING AND MAINtENANCE

4
● Regularly clean the housing with a soft cloth.
● Keep the ventilation slots free from dust and
Replacing the grinding disc (fig. B)
Worn or damaged grinding discs must be
replaced immediately.
2
● To remove the old grinding disc (9), proceed
● To mount the new grinding disc (9), proceed
Carbon brushes
If the carbon brushes are worn, the carbon brushes
must be replaced by the customer service
department of the manufacturer or a similarly
qualified person.
wARRANty
Consult the enclosed warranty terms.
ENVIRONMENt
Disposal
8
The product, the accessories, and the packaging
must be sorted for environmentally friendly
recycling.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2002/96/EC
for Waste Electrical and Electronic Equipment
machine. Let the machine do the work.
machine to come to a complete standstill
before putting the machine down.
Before cleaning and maintenance,
always switch off the machine and
remove the mains plug from the mains.
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.
Only use sharp and undamaged grinding
discs.
as described in the section
"Mounting and removing the grinding disc".
as described in the section
"Mounting and removing the grinding disc".
Ferm