Test The Oven Before Use - LG WDES9428F Manual De Instalación

Ocultar thumbs Ver también para WDES9428F:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

16 INSTALLATION
5
Close the oven door.
NOTE
• Use two hands to remove the oven door.
• When you install the oven door, be carefull not
to bump the metal bottom trim.
Assembling the Bottom Trim and Vent
Trim (Decor)
Metal bottom trim (Vent)
a
• Keep oven vents unobstructed. Replace the
bottom trim if it becomes bent or deformed.
Never block the vent with plastic or heat-
sensitive items.
Correct position
1 4/9"
(1.1 cm)
• Ensure that the metal bottom trim is correctly
installed.
Vent trim (Decor)
b
• After installing the oven in the cabinet, assemble
vent tirm (Decor) with 2 screws
NOTE
• Use two hands to remove the oven door.
Wrong position
(4X10).
c

Test the Oven Before Use

Each of the functions has been factory checked
before shipping. However, it is suggested that you
verify the operation of the oven once more. Refer
to the owner's manual and follow the instructions
for the basic check.
• Turn on the power supply. The initial signal
sound is heard and the Clock segment appears
in the display.
NOTE
• Depending on the model, some of the following
functions may not be available.
1
Turn on the power supply. The initial signal
sound will be heard.
2
Check the operation of the broil mode.
• When the oven is set to broil, the upper
element in the oven should become red.
After a few minutes, partially open the oven
door. You should feel heat from the oven.
Touch Stop.
3
Check the operation of the bake mode.
• After setting the oven to 350
baking, the temperature of the oven in the
display should increase. Touch Stop.
4
Check the operation of the convection bake
mode.
• After setting the oven to 350
convection baking, the fan inside the oven
should come on with the door closed. Touch
Stop.
5
Turn on and off the oven light to check that
the lights are in normal condition.
6
Check the operation of the burner for each
convection mode.
• After setting the oven to 350
each convection mode, the back element
should light up and the fan inside the oven
should come on with the door closed.
NOTE
• A small amount of smoke and odor may be
noticeable during the initial break-in period.
• If the oven does not operate properly or an F-,
followed by a number, appears in the display,
/ 177
for
/ 177
for
/ 177
for

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Wses4728f

Tabla de contenido