Filling The Magazine; Eu Declaration Of Conformity - KMR SKDA664-G648E Instrucciones Adicionales De Uso

Device-specific additional instructions for nailer
4

Filling the magazine

•
Ensure that nailer and fasteners are compatible (Chap. 1) with
each other.
•
Check fasteners for proper condition.
•
Put nailer carefully down in defined safe resting position (Chap. 3):
The driving nose must point away from any person. It must be
impossible to unintendly actuate trigger and/or release protection.
•
Put nailer carefully down in defined safe resting position (Chap. 3):
The driving nose must point away from any person. It must be
impossible to unintendly actuate trigger and/or release protection
5 Adjusting drive-in depth
Mechanical adjustment of drive-in depth:
•
Turn adjustment knob 1 for deeper countersunk nails clockwise.
Turn anti-clockwise to lower the nails less deeply.
6 Removing stuck fasteners from the driving channel
•
Disconnect the tool from the compressed air supply. Remove the
staples from the device. Actuate the locking lever 1 and open
the head piece flap 2. Remove jammed staples. Close the head
piece flap 1 again, connect the tool to the pressure supply and
refill the magazine with staples.
7

EU Declaration of conformity

The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO8662 A1:2001 (Vibrations at driving tools).
Date: 20.07.2021
------------------------------------------
Dr. Jörg Dalhöfer, CEO
SKDA664-G648E
.
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 7