The following is a table of a few useful suggestions for the diagnosis and solution of possible module
problems.
Problem
Red Led ON
No output signal
No Audio/Video output
incapsulated signal
All the streaming programs
are freezing
LAN services blocked
Slow response during the
programmation by using the
TPE
Unable to manage the mo-
dule using the TPE or via
WEB Interface
Impossibile IP address
changing with TPE
The selection audio-pro-
gram instead of video-pro-
gram has a slight freezing
picture showed in the IP
Set-top-box
The program does not start
streaming on the IP Set-
top-box after a mains inter-
ruption
All manuals and user guides at all-guides.com
8. TROUBLESHOOTING
Explanation
General malfunction
The antenna is disconnected
Excedancees of the maximum
bit-rate manageable from
any module. A just activa-
ted channel is automatically
stopped if the available PIDs
are finished or if a programme
used a not valid PID.
One or more ethernet switch
could not properly manage
the IP multicast traffic gen-
erated by several SIG7710
modules connected to the
LAN
Multicast Traffic on the LAN
too high
RAM overloaded
High Multicast traffic gener-
ated by the module present
on the LAN
The trouble is related to the
management of buffer memo-
ry of the IP Set-top-box
The trouble is related to the
managements of programs in
the IP Set-top-box
44
Solution
Contact FRACARRO Technical
Support
Check the connection of the anten-
na
Verify the selected SAT programs
you want to put over IP
Please referring to the network
administrator of the LAN
1.
Turn off one or more streaming
programs;
.
Proceed with the SIG7710
module settings;
3.
Re-enable the programs again
Before module via TPE or via WEB
is recommended to:
1.
disable monitoring set to Fra-
carro Headend Management;
.
update the module
3.
restore monitoring
1.
Unplug the network intercon-
nection patch cable;
.
make changes;
3.
Restore the link
Refer to the instructions of the IP
Set-top-box manifacturer
Refer to the instructions of the IP
Set-top-box manifacturer