Conergy SmartControl System Manual De Uso página 43

6 Assembly and installation
42
CAUTION
Outdoor installation will damage the devices!
The CAN converter may not be installed outdoors without
additional protection.
| When using the device outside of enclosed spaces, install it
in an additional housing.
CAUTION!
The Conergy SmartControl carries high voltages!
All devices installed next to the Conergy SmartControl and
the power supply unit must be equipped with at least basic
insulation.
| The CAN converter should be installed so that it is not in
contact with the 230 V power supply.
Mounting on the DIN top-hat rail
1. Push two mounting rail bus connectors next to the power
supply unit (1) and the Conergy SmartControl (2) on the
top-hat rail.
(1)
Fig. 6-7: Plugging the CAN converter onto the top-hat rail
2. Fit the CAN converter (4) to the projecting cable pins of
the mounting rail bus connector (2).
The CAN converter and the Conergy SmartControl are
connected to one another via the DIN top-hat rail and the
mounting rail bus connectors.
Operating manual
(2)
(4)
Conergy SmartControl System
(3)