Conergy SmartControl System Manual De Uso página 46

Connecting the ET
sensor
Conergy SmartControl System
CAUTION
Incorrect cable assignment can cause damage to
property.
Incorrect cable assignments can damage the Conergy
SmartControl.
| Check the correct assignment of the cables to the female
connectors.
| Note the assignment of the strands of the connection cable
between the Conergy SmartControl and the ET sensor. The
connection cable must be connected to the ET sensor
using the same assignments!
Once you have connected the ET sensor, you must carry
forward the cable assignment you made there (see
Chapter 6.1, page 35)!
Connecting the ET sensors cables
1. Loosen the connecting screw on one lead.
2. Put a cable end sleeve on the end of the cable.
3. Insert the cable end into the screw terminal.
4. Tighten the terminal screw.
5. Check that the screw terminal is fastened securely.
6. Repeat this procedure for all cables.
Fig. 6-9: Connecting the terminal strip to the Conergy
SmartControl
Operating manual
6 Assembly and installation
45