Conergy SmartControl System Manual De Uso página 58

Terminator
Conergy SmartControl System
Fig. 6-18: Inverter RS485 connection
2. Fit the D-SUB plug to the inverter RS485 connection and
secure.
The inverter RS485 connection for the connection cable is
located on the underside of the control unit and is protected
by a dummy plug.
Every Conergy IPG series central inverter has two RS485
interfaces. To one interface connect the CAN converter
connection cable. At the second interface fit a bus
termination in the form of a 120
included in the delivery of the inverter.
WARNING
Inadequate terminating resistor may cause short circuit!
Ω
| Only use the 120
delivery of the inverter.
Operating manual
6 Assembly and installation
Ω
resistor The resistor is
terminating resistor included in the
(1)
on
off
57