Conergy Smartcontrol Function Test - Conergy SmartControl System Manual De Uso

Conergy SmartControl System
7.2

Conergy SmartControl function test

You can check the fault-free dial-in function of theConergy
SmartControl with the aid of the LED displays.
Status
Measure
Transfer
Alarm
Fig. 7-5: LED indicators on the Conergy SmartControl
If the power supply unit is connected to the Conergy
SmartControl and mains voltage is present, then the Conergy
SmartControl starts dialling in automatically. The individual
steps of the dial-in process are shown by green lit or flashing
LED displays.
Sequence for commissioning the Conergy SmartControl:
Status Measure
Once the basic settings have been successfully retrieved, the
LED displays switch off. Proper operation begins. The LED
display Status flashes.
Operating manual
7 Commissioning
Transfer Alarm Meaning
LED test (approx. 5 s)
Initial dial-in alarm
(approx. 20 s)
Establishing the
connection between
the Conergy
SmartControl and the
system monitoring
portal
Successful retrieval of
basic settings.
67