auna Silverstar Amp Manual Del Usuario página 43

Manual settings
Choose DHCP enable/disable
NetRemote PIN setup
Allows you to define a PIN number to be entered before being able to
connect to radio remotely over a network
Network profile
This displays a list of the networks remembered by radio (up to a maximum
of 4). You can see the list of registered networks through Menu > System
settings > Network > Network profile>. From here you can delete unwanted
networks by turning and press OK then confirming delete Yes.
Clear network settings
This option will clear current network settings, to allow you to join an
alternative network more easily.
Keep network connected
Choose Yes or no to keep network connected or not.
Time/Date
• Set Time/Date
• Auto Update
• Set Format
Set Time/Date
The date and time are displayed as dd-mm-yyyy with the first value, dd,
active (flashing). Adjust each value with the knob control. As each value is
set by pressing the knob control, the next value becomes active ready for
adjustment.
Auto-update (from DAB, FM or Network
Auto-update works with data sent over DAB, FM or the Internet. The clock
is only updated when in a corresponding mode, so it is best to select a
mode you use regularly. DAB and FM use time signals broadcost with radio
transmissions. Network uses a time signal sent from the internet radio
portal when in any network-connected mode.
1. Select Update from DAB, update from FM, update from Network or No
update.
2. If you are updating from the network, set your time zone.
3. If your country uses a daylight saving, the automatically updated time
from the network may be wrong by one hour. When daylight saving
adjustments is in effect, such as British Summer Time (BST), turn on the
Daylight savings option to rectify this.
EN
43