Orbegozo VP 8600 Manual De Instrucciones página 17

VP 8600
After the cumulative run time of the pump is 40 hours, the indicator light (14) for the replacement of the
resin anti-scale filter will come on and it will need to be replaced. After replacement, press the reset
button (14) and the light will turn off.
DRY IRONING
Press the power button with the indicator light (13) and then turn the temperature control dial (3) to any
position in the uncoloured area. Wait until the thermostat operating light (5) stops flashing and indicates
that the desired temperature has been reached.
SELF-CLEANING
1. Self-cleaning reminder.
When the steam usage time reaches 7 hours, the self-cleaning light will blink. You must follow the
process below to activate the self-cleaning mode. However you can activate this mode at any time you
want, it is not necessary to activate the warning.
IMPORTANT: You must perform the self-cleaning with the cold iron and in a place that can be wet since
the iron will expel a large amount of water during the process.
2. Self-cleaning mode
Press the MODE button for 5 seconds to enter self-cleaning mode. The SELF CLEAN light will begin to
flash and the following processes will occur automatically. You should not touch any buttons or interrupt
the process.
(1) The iron will start to heat up until the thermostat operation light stops flashing.
(2) The pump will run for 45 seconds CAUTION: Large amounts of hot water may be generated during
this process.
(3) The pump will turn off and the thermostat operation indicator light will flash again. Once it reaches its
fixed position, the iron will return to its off position and the self-cleaning process is complete. Allow the
soleplate to cool down and clean any limescale that may remain on it.
SUGGESTIONS
-Divide the laundry according to the correct ironing temperatures. Start by ironing those items that
require a lower temperature. For more complete details, see the table at the end of this manual.
17