Chicco Best Friend+ Instrucciones De Uso página 14

• Before assembly, check that the
product and all of its components
have not been damaged during
transportation. Should any part be
damaged, do not use it and keep it
out of reach of children.
• Do not use this product if some parts
are broken, torn or missing.
• The product must be assembled by
an adult.
• This product must only be used by
an adult.
• Make sure that the person using the
stroller knows how to do it in the
safest way.
• Ensure that during these operations
the moveable parts of the stroller do
not come into contact with your child.
• Never use the stroller on staircases or
escalators: you could suddenly lose
control of it.
• Always pay attention when going
up and down steps or pavements.
• Do not let your child climb onto the
storage basket: it could break the
basket, injure the child and overturn
the stroller.
• To avoid all strangulation risks, never
give children objects with cords or
strings attached, or leave them with
in proximity of such objects.
• If the stroller has been exposed di-
rectly to sunlight for a long time, you
must let it cool down before placing
your child inside of it.
• Prolonged exposure to direct sun-
light may cause the material and
fabric to fade.
• Prevent the stroller from contact with
salty water. It might cause the forma-
tion of rust.
• Do not use the stroller on the beach.
• When unused, the stroller should be
kept out of reach of children.
LIST OF COMPONENTS
• Frame
• Seat
• 2 Rear wheels
• 2 front wheels
• Bumper bar
• Storage basket
• Hood
• 2 shoulder strap pads and one crotch strap cover pad
(comfort kit)
• Rain cover
Important Note: The pictures and instructions contained in
the booklet are referred to the complete stroller model. Some
of the components and functions described here may vary
depending on the model purchased.
ADVICES FOR CLEANING AND MAINTENANCE
This product requires periodical maintenance. The cleaning and
maintenance of the product must only be carried out by an adult.
CLEANING
The cover cannot be removed. Clean the fabric parts using a
wet terry towel and neutral soap. Periodically wipe clean plastic
parts with a soft damp cloth. Dry the metal parts, after possible
contact with water, in order to avoid the formation of rust. Do
not use solvents or abrasive products. The washing symbols
and relative meanings are indicated below:
Do not wash
Do not bleach
30° C
Do not tumble dry
Do not iron
Do not dry clean
MAINTENANCE
Lubricate the moving parts only if necessary, with a light applica-
tion of a silicone based lubricant. Regularly check the condition
of the wheels and, keep them clean from dust and sand. Make
sure that all plastic parts that slide on the metal tubes are clean
from dust, dirt and sand, in order to avoid frictions that may
compromise the optimal performance of the stroller. Keep the
stroller in a dry place.
FIRST ASSEMBLY OF THE STROLLER
1. Release the closing device (Fig. 1) and push the front part of
the stroller forward until you hear a click (Fig. 2).
2. Insert the front wheel into the appropriate hole until hearing
a locking click (Fig. 3). Repeat the same operation for the
second front wheel.
3. To mount the rear wheel, insert the wheel pin into the hole
on the rear leg tube, ensuring that the flat part of the pin
corresponds with the hole in the frame as shown in Figure 4.
Repeat the same operation for the other wheel.
WARNING: Before using the stroller, make sure that the wheels
are well secured to the structure.
4. Install the basket, positioning the part with the strips in the
direction of the front tube. Insert the strips into the designated
holes on the frame, fastening them with the specific snap
buttons (Fig. 5).
Secure the central part of the basket to the rear tube with the
14