2.10 Completion Of Work - ATH-Heinl W142 Instrucciones De Operación

The display shows [CAL.] – [15.0]
This value can be changed using D+ / D-
Confirm with [ALU].
Then secure an appropriate wheel (e.g. 16") on the machine
Next, position the plunge on the edge of the wheel rim
Press the ALU button
The display shows [CAL.] – [End]
If the display shows [CAL] – [10], this means that the calibration
has been unsuccessful and must be repeated.
When using the ALU S programme, it is recommend that the display threshold be set to 10 g.
Why:
- Because the machine records the dynamic and static imbalance, the operating characteristics of the
wheel change when the weights are affixed.
- Because the weights are positioned further towards the middle of the wheel rim, the weights
automatically achieve greater and more precise balancing results.
- Because the machine requires the balancing weights at one point and there are different adhesive
weight systems, this can cause a large weight distribution.
- The adhesive weights are not 100 % affixed in the correct location.

2.10 Completion of Work

Before commissioning, check all fastening screws, electrical, pneumatic and hydraulic
lines and, if necessary, tighten these. Warning: in some cases, this must be checked at
regular intervals and tightened if necessary (note in the instructions).
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2020-10
All manuals and user guides at all-guides.com
Manufacturer ATH-Heinl GmbH & CO.KG
- 34 -