Remington High Precision HC600 Manual Del Usuario página 6

ENGLISH
CARE FOR YOUR HAIRCLIPPER
Your clipper is fi tted with high quality titanium blades. To ensure long lasting performance
of your clipper, clean the blades and unit regularly. The easiest and the most hygienic way
to clean the clipper is by rinsing the trimmer blade after use with warm water. Always keep
the protective cap on the trimmer blade and lubricate the clipper lightly before and after
cleaning.
AFTER EACH USE
Ensure the clipper is switched off and disconnected from the mains.
Brush or rinse the accumulated hair from the blades. Do not submerge the clipper in
water.
Place one or two drops of oil on the blades. Turn the clipper on to distribute the oil
evenly, wipe off any excess oil. Excess oil will cause damage to your product.
To clean the unit, wipe with a damp cloth and dry immediately.
Note: Ensure that the clipper is turned off when cleaning or applying oil.
EVERY SIX MONTHS
At regular intervals the blade set should be removed and cleaned.
Remove the 2 screws retaining the fi xed blade with a screwdriver. Do not remove blade
set.
Brush out hairs from between the blades with soft cleaning brush. Do not remove the
lubricating grease from the blades. It is not necessary to remove the small moving blade
from the unit.
If the moving blade has been removed this can be re-fi tted by slotting the long grooved
edge of the blade onto the two white plastic guide ridges and then seating the blade over
the plastic actuator bar. The fi xed blade is fi tted with the raised profi le pointing outwards
and fi xed with the 2 screws.
Before fully tightening the 2 screws, adjust the taper lever to the lower position and align
the blades so that their cutting edges are parallel to one another. Tighten the 2 screws.
Note that if the blades are not correctly aligned then cutting effi ciency will be impaired.
Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.
4
070774_REM_IFU_HC350_RC_innen.in4 4 070774_REM_IFU_HC350_RC_innen.in4 4
All manuals and user guides at all-guides.com
10.31.2007 15:33:47 Uhr 10.31.2007 15:33:47 Uhr