Noise Level - IPC GS 1/41 OVEN Manual Del Usuario

GB
DESCRIPTION AND ASSEMBLY
A - Vacuum head
B - Switch
C - Meta-aramidic filter to be inserted into the
container.
D - Hooks for tightening of vacuum head to tank
E - Tank
F - Rolling wheels
H - Suction inlet
M - Brush
N - Steel extension.
O - Flexible hose
Q - Wand
ATTENTION
In order to keep the device perfectly functioning please
clean the meta-aramidic filter by shaking it after use.
INDICATIONS TO BE SCRUPULOUSLY ADHERED TO
•
This apparatus is not to be used by people (children included) with
reduced physical, sensorial or mental capacities or without any ex-
perience and knowledge, unless they did not receive instructions
relative to the use of the apparatus and are controlled by a person
responsible for their safety.
• Children should be controlled so that they didn't play with the appa-
ratus.
• The packaging components could constitute potential dangers (as
for example plastic bags): they must be kept away from children's
reach and from other people or animal not conscious of their ac-
tions.
• Any different use from that indicated in this manual could constitute
a danger, therefore, it must be avoided.
• ATTENTION: do not use outdoor in case of low temperature.
• ATTENTION: this apparatus can be used for suction dry only, and it
cannot be stored in the open or under damp conditions.
• ATTENTION: Don't ever point the suction opening towards delicate
parts of the body – of people or animals - such as eyes, ears, mouth,
etc.
• ATTENTION: if the apparatus is fitted with a supplementary plug, do
not exceed the power reported on the plug. Non-compliance with
this norm could cause fires and damages even lethal to the user.
• ATTENTION the apparatus is not suitable for areas protected again-
st electrostatic discharges.
• ATTENTION: use only the brushes supplied with the apparatus or
those specified in the instruction manual. Using other brushes could
jeopardize safety.
• ATTENTION: Do not leave the functioning apparatus unattended,
always remove the plug from the socket when not using the appa-
ratus and store it away from the reach of children or people who are
not conscious of their own actions.
• ATTENTION: This apparatus is not suitable for recollection of dange-
rous dust. Do not exhaust toxic, explosive, flammable or incandes-
cent substances. OVEN accessories kits are resistant to 120°C or
200°C according to the typology. The unit can be used only for some
seconds at high temperature. Prolonged use at high temperature
can damage the machine if the internal temperature goes more than
90°C. Vacuuming at a high temperature it is recommended to do it
intermittently in order to suck cool air and reduce the temperature
of the machine.
• Every part of the apparatus must be correctly assembled before
NOISE LEVEL: Values measured according to EN 60704 - 1 (1997) / EN 60704 -2 - 1 (2001) rules. Measurement A for the sound pressure
level of the machine is ≤ 76 dB (A) Under unfavourable feed conditions, the appliance may cause temporary drops in voltage.
6
OPERATING INSTRUCTION
- Insert meta-aramidic filter into the tank (Fig. 1)
- Assembly the head on tank and lock it by hooks
(Fig. 2)
- Connect the flexible hose into the inlet
(Fig. 3)
- Insert steel extension at the hose end (Fig. 4)
- Connect brush (Fig. 5)
- Connect the plug to power socket then switch on
the equipment (Fig. 6)
using it. Verify, furthermore, that the filtering elements have been
correctly and efficiently assembled.
• Ascertain that the values indicated on the engine block correspond
to those of the network to which you intend to connect the appara-
tus and that the socket is compatible with the plug.
• Do not aspire materials that could damage the filtering elements
(such as glass, metal etc.).
• Do not ever pull or lift the apparatus through the electrical cable.
• Do not immerge the apparatus into water and neither use water jets
to clean it.
• Always remove the plug from the socket before performing any ope-
ration.
• Regularly control the feeding cable looking for damages, cracks or
ageing. Substitute the cable before using it further.
• The substitution of the damaged cable must be done by the tech
assistance service or by competent authorized personnel with reco-
gnized qualification.
• When using electrical extensions, make sure that these are com-
patible with the power cable and that it does not touch liquids or
conductive surfaces.
• Specialized personnel must always carry out maintenance and
repairs; any damaged part must be substituted with original spare
parts.
• ATTENTION: it is forbidden to carry out changes to the apparatus.
Tampering could cause fires and damages even lethal to the user
and the forfeiture of the guarantee.
• The manufacturer declines any responsibility for damages caused to
people or things due to non-compliance with these instructions or if
the apparatus is unreasonably used.