Harry 721 Manual De Instrucciones Y De Mantenimiento página 8

HARRY
3) ASSEMBLY
Tools:
To assemble the HARRY mower you will need:
- One straight head screwdriver;
- Two small adjustable wrenches.
Assembly of deflector and handle:
1) Place spring into holes in deflector. Set on ground next to back of
mower;
2) Place handle on mower . Take handle rod and from left side of deck
pass through holes on left side of handle and deck. Now place deflector
and spring holes in path of handle rod. Push rod, by tapping with
palm of hand, through to other side of deck and through hole on right
side of handle. During this operation, it's helpful to have someone
else holding handle in place.
Now use large threaded knob to tighten down nut.
Assembly of fabric grasscatcher:
1) Slip the wire frame into the fabric bag, keep the metal handle outside
of the fabric.
The metal handle and fabric bag cloth handle will both be at top side
of the catcher. The plastic sheet will be on the bottom.
2) Secure the 4 sides of fabric bag to rectangular frame opening by
slipping plastic ends of bag over the metal frame. Leave top left and
right of bag off.
3) Place grille over the two hooks of the catcher. Be sure grille flanges
face mower. Mower side and catcher side are indicated on grille.
4) Place metal plates on frame brackets, just aft of each hook. Secure to
bracket with flat head bolts, nuts and washer.
The other end of clip should now cover the top of the grille, just aft the
hook... thus preventing the grille from falling off when the grille is
raised to full open position at time of emptying grass cuttings.
Slip bag top left and right plastic ends over the metal frame.
5) Attach spoon to lower right from side of grille with 4 straight head
screws and nuts.
Tighten with screwdriver and small adjustable wrench.
6) To attach grasscatcher to mower stand on right side of mower lift
deflector with right hand, and with left hand hook catcher onto two
open areas of handle rod.
8
All manuals and user guides at all-guides.com