Accessories - Workzone WMW 300-1 Manual Del Usuario

Problem
2.
The extractor
line/dust
extractor is
loose/keeps
falling off.
3.
The multi-
function tool
cannot be
switched on.
4.
The tool hol-
der does not
move after
switching on
the multifun-
ction tool.
5. The oscilla-
tion/speed
can not be
increased or
decreased.

Accessories

You can purchase suitable accessories such as sanding sheets from commercial
outlets (e.g. at Bosch).
AFTER SALES SUPPORT
USA
Possible cause
The extractor line/the
dust extractor is not
properly mounted.
The socket has no
power.
The power plug has
not been inserted
properly.
The power plug is
not connected to a
socket.
The On/Off switch is
stuck.
The power plug/
On/Off switch is
defective.
There is dirt, wood
chips or other objects
located in the gap of
the tool holder.
The multifunction-
tool is defective.
The speed control is
dirty.
1 866 326-6446
Troubleshooting
Use the holding clips to secure
the extractor line on the housing
of the multifunction tool.
Push the dust extractor firmly
onto the connecting nozzle
of the extractor line and turn
it counterclockwise to fix it in
place.
Check the socket by connecting
another device.
Check to make sure that the
power plug is properly seated.
Insert the power plug in a
socket.
Keep the On/Off switch clean
as described in the chapter
"Cleaning and maintenance".
Contact the customer service
team of the manufacturer.
If necessary, clean the gap of
the tool holder with a vacuum
cleaner.
Contact the customer service
team of the manufacturer.
If necessary, clean the speed
control and the gap with a
vacuum cleaner.
meister-service@meister-werkzeuge.de
USA
Accessories
19