Turning On And Off - volkano Silenco Serie Manual Del Usuario

You must completely charge the Silenco headphones before the first use.
Connect the USB charging cable to any powered USB port and to the Micro-USB port on the Left
earcup. Make sure it is plugged in fully. The LED light will be red while the headphones are charging
and will turn blue when the headphones are ready for use.
To turn on, press and hold the
The headphones will play a short tune, the blue LED light will remain on for 2 seconds then
start flashing red and blue and make a short high pitch tone. To turn off, press and hold
the Bluetooth Button for approximately 4 seconds. The headphones will make a low pitch tone
® ®
then turn off.
Your headphones must be paired to a Bluetooth
to pair your headphones once with each device.
1. Open the Bluetooth
more details). Some devices require you to select "Search for Devices" or "Add New Device" in
order to create a Bluetooth
2. With the headphones turned off, press and hold the
3 seconds until the headphones play a short tune. The LED light will flash red and blue at a high
speed while the headphones are in pairing mode.
3. Wait until you see "Silenco" on your device screen.
4. Select "Silenco" on your device and follow any further prompts to pair. Once pairing is complete
and a connection is established, the headphones will chime and the blue LED light will flash at a
slower rate.
INSTRUCTIONS FOR USE:

TURNING ON AND OFF

Bluetooth
®
PAIRING WITH BLUETOOTH
menu on the device you wish to pair (see "Locating the Bluetooth
®
pairing.
®
CHARGING
Button for approximately 3 seconds.
®
®
device before it can be used. It is only necessary
®
Bluetooth
®
3
DEVICES
Button for approximately
®
Menu" for
®