Connecting To Network - Korenix JetNet 3008 Serie Guía De Instalación Rápida

All manuals and user guides at all-guides.com

Connecting to Network

1. Connecting the Ethernet Ports: Connect one end of an Ethernet cable into the UTP port of
JetNet 3008/3008f, while the other end is connected to the attached networking device. All
UTP ports support auto MDI/MDIX function. The Speed LED will turn on for 100M link and
turn off for 10Mbps link, the LNK/ACT LED will turn on for link up and blinking for packet
transmit and receive. The fiber port only support 1 LED for Link and Activity.
2. Connecting the Fiber Port (JetNet 3008f) : Connect the fiber port on your JetNet 3008f to
another Fiber Ethernet device, by following the figure below. Wrong connection will cause the
fiber port not working properly.
ATTENTION
This is a Class 1 Laser/LED product.
Don't stare into the Laser/LED Beam.
DIP Switch Settings for Alarm Relay Output
Pin No. # Status Description
ON To enable port link down alarm at this port.
P1 to P8
(Pin1 ~ 8)
To disable port link down alarm at this port.
Off
ON To enable power failure alarm.
P9
To disable power failure alarm.
Off
Korenix Customer Service
KoreCARE is Korenix Technology's global service center, where our professional staff are
ready to solve your problems at any time
Korenix global service center's e-mail is KoreCARE@korenix.com
RX RX
TX TX
Cable Wiring(SC to SC)
TX A RX B
RX A TX B