Fanimation AIRE DECOR BP200 1 Serie Manual Del Usuario página 5

6. MAKE THE ELECTRIC
CONNECTIONS
WARNING: To avoid possible electrical shock,
be sure electricity is turned off at the main fuse box
before wiring. (Fig. 13)
Note: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
Option A
1. Connect the green grounding lead from the
downrod and the green grounding lead from the
hanger bracket to the supply grounding conductor
(this may be a bare wire or wire with green colored
insulation). Securely connect wires with wire
connector. Securely connect the white fan motor wire
to the white supply (neutral) wire using wire connector.
Securely connect the black fan motor wire and blue
wire to the black supply wire using wire connector.
(Fig. 14A)
Note: If you feel that you do not have enough
electrical wiring knowledge or experience, have your
fan installed by a licensed electrician.
WARNING: Check to see that all connections are tight,
including ground, and that no bare wire is visible at the
wire connectors except for the ground wire. Do not
operate fan until the blades are in place. Noise and
motor damage could result.
2. After connections have been made, taking care not
to pinch the wires and put the white and green leads
to one side and the black leads towards the other side,
the connection should be turned upward and carefully
push leads into the outlet box. The wires should be
spread apart with the grounded conductor and the
equipment-grounding conductor on one side of the
outlet box and the ungrounded conductor on the other
side. (Fig. 15A)
Main fuse box
Figure 13
Figure 14A
Figure 15A
7
Option B - with a red wire available
1. Connect the green grounding lead from the
downrod and the green grounding lead from the
hanger bracket to the supply grounding conductor
(this may be a bare wire or wire with green colored
insulation). Securely connect wires with wire
connector. Securely connect the white fan motor wire
to the white supply (neutral) wire using wire connector.
Securely connect the black fan motor wire to the black
supply wire using wire connector. Securely connect
the blue fan motor wire to the red supply wire using
wire connector. (Fig. 14B)
Note: If you feel that you do not have enough
electrical wiring knowledge or experience, have your
fan installed by a licensed electrician.
WARNING: Check to see that all connections are tight,
including ground, and that no bare wire is visible at the
wire connectors except for the ground wire. Do not
operate fan until the blades are in place. Noise and
motor damage could result.
2. After connections have been made, taking care not
to pinch the wires and put the white and green leads
to one side and the black leads towards the other side,
the connection should be turned upward and carefully
push leads into the outlet box. The wires should be
spread apart with the grounded conductor and the
equipment-grounding conductor on one side of the
outlet box and the ungrounded conductor on the other
side. (Fig. 15B)
Figure 14B
Figure 15B
8