Charging Mobile Devices Wirelessly And Via Usb Simultaneously - Tronic Qi TPBQ 10000 A1 Instrucciones De Utilización Y De Seguridad

To end the charging process, disconnect the USB charging
cable from the mobile device and the power bank
power bank
will switch off after approx. 30 seconds.
To switch off the power bank
disconnected: press the On/off button
bank 1 and the LED display for battery capacity
switch off.
*
1) I f you use all the USB ports, a voltage of 5 V will output at
all the outputs. The maximum output current must not exceed
3 A for all outputs. If all USB outputs are used, fast charge
mode will not be activated.
2) If USB type A output
or PD mode, and another USB port is connected to another
device for charging, the quick charge or PD mode will be
terminated and switched to normal charge mode. All devices
will now be charged at 5 V each.
Charging mobile devices wirelessly and
via USB simultaneously
You can charge up to three devices at the same time using the
USB ports and the wireless charging function of the power bank
. If all outputs are used at the same time, the sum of the
1
output current must not exceed 3 A.
Follow the procedures under the section "Charging mobile
devices with the power bank
charge your devices via USB.
During the USB charging process, put a Qi compatible
device on the Qi charging surface
US-EN 22
1 and the LED display for battery capacity
or PD output
9
after your mobile device is
1
3 twice. The power
is in quick charge
6
1 via USB output ports" to
2 of the power bank
1 . The
5
5 will
1