Maintenance; Grease Filters - Smeg KSEV96X Manual De Instrucciones

MAINTENANCE

CLEANING METAL SELF- SUPPORTING GREASE FILTERS
Alarm signal reset
• Switch off the lights and extractor motor.
• Press button V2 for at least 3 seconds, until the
leds start to flash.
Cleaning the filters
• The filters must be cleaned when led S1 flashes
or at least every 2 months of operation, or more
frequently for particularly heavy usage.
• Remove the filters one at a time by pushing them
towards the back of the group and pulling down
at the same time.
• Wash the filters, taking care not to bend them.
Allow them to dry before refitting.
• When refitting the filters, make sure that the
handle is visible on the outside.
• Disconnect the hood by switching off the two-
pole switch on the mains power supply line, or
by switching off the main power switch.
• Remove the grease filters from the hood.
• If the hood is of the recirculation type, remove
the odour filters.
• Remove the halogen-lamps support by taking
off the two fixing screws.
• Disconnect the power connector Ca and the
control and lighting connector Cmd on the sides
of the unit.
• Turn the levers Lb locking the suction unit, so
that they disconnect from the pins.
• Pull the suction unit forwards so that it unhooks
from the support pins, and remove it downwards
through the air outlet.
GB

Grease filters

Disconnecting the Suction Unit
Ca
Lb
Cmd
18