Dos And Don'ts; How To Clean - Tommee Tippee Made for Me Manual Del Usuario

DO NOT wash these parts:
Air tubes – two plastic tubes with
purple connectors at each end that
attach your breast pump to the power
unit.
Power unit – small, portable motor that
powers the massage and expression
features of your breast pump.
A. Power
use to turn pump on and off,
and pause during pumping.
B. Mode button
switch between massage
and expression
C. Double/single pump
switch between double
and single pump modes.
D. Increase suction power
E. Decrease suction power

Dos and Don'ts

DO wash your hands with soap and
water and dry thoroughly before
handling your breast pump.
DO thoroughly clean and sterilize
all the parts of your breast pump
that come into contact with milk,
following the instructions below. Do
this before you use it for the first
time and after every use.

How to clean

Separate each part of each pump
handset and wash in clean soapy
water. Don't use water that you've
used for cleaning other products.
DO NOT wash the air tubes.
Rinse thoroughly with clean water.
You can also wash the pump handset
parts in the top rack of a dishwasher.
Place the purple duck-bill valve in the
cutlery rack or dishwasher basket to
keep it safe.
modes.
F. LED display – shows time.
G. LED display – shows mode level,
there are 5 massage levels and 9
expression levels.
H. LED display – shows battery
charge level.
I. Air tube connector – connect your
air tubes to the power unit here.
J. USB socket – connect this to a
USB power source or adapter
to recharge.
I
DON'T wash or sterilize the air tubes.
This can cause bacteria to build up in
the tubes and will damage the power
unit.
DON'T wash, sterilize or heat the
power unit. This is dangerous and will
damage your power unit.
Sterilize all parts of both pump
handsets using either cold water
sterilization, microwave sterilization,
boiling water, or electric steam
sterilization.
DO NOT sterilize the air tubes.
For best results use Tommee Tippee
electric or microwave sterilizers.
If you need to clean the power unit,
USB cable or air tubes, wipe the
outside with a clean damp cloth.
DO NOT wash any of these parts.
J
3