Becken baby BBM3554 BU Manual De Instrucciones página 17

The audio monitor produces high-pitched noise
• The parent unit may be too close to the baby unit. Make sure the
parent unit and the baby unit are at least 1.5 meters away from one
another.
The parent unit plays any sounds from the baby unit and I think it
is too noisy
• You may need to adjust the speaker volume on the parent unit.
The parent unit does not play any sound when there is noise from
the baby unit
• Make sure the parent unit is powered up by connecting it to mains
power or to the rechargeable batteries provided.
• Make sure the parent unit is turned on and the speaker volume is
not set to off.
• The parent unit may be too far away from the baby unit. Move the
parent unit closer to the baby unit (but not less than 1.5 meters).
• If the parent unit is powered by the provided batteries, make sure
there is sufficient charge. Charge the battery in the parent unit for
up to 12 hours.
• Large obstructions may impact the reception. Try to relocate the
baby unit, away from large obstructions such as walls and doors.
• Remove the batteries and then install it again. Turn on the baby unit
and the parent unit. Allow up to one minute for the parent unit and
the baby unit to synchronize.
• Other electronic products may cause interference with your audio
monitor. Try installing your audio monitor as far away from these
electronic devices as possible: wireless routers, radios, cellular
telephones, intercoms, room monitors, televisions, personal
computers, kitchen appliances and cordless telephones.
Digital Audio Baby Monitor | Vigilabebés con Audio Digital
AF Manual de Instruç o ̃ e s Baby Monitor BBM3554 A5.indd 17
Intercomunicador Áudio Digital de Bebés
EN
17
30/08/2019 10:48