Stihl MS 193 T Manual De Instrucciones página 19

chain is pinched or otherwise caught in
the cut. Clutch slippage can cause
excessive heat, leading to severe
damage of the motor housing, clutch
and oiler component and may interfere
with the operation of the chain brake. If
clutch slippage in excess of 3 seconds
has occurred, allow the motor housing to
cool before proceeding and check the
operation of your chain brake as
described in the chapter entitled "Chain
Brake" of your instruction manual. Also
make sure that the saw chain is not
turning at idle speed (see above at
"Important Adjustments").
Low Kickback Saw Chain and Reduced
Kickback Bars
STIHL offers a variety of bars and saw
chains. STIHL reduced kickback bars
and low kickback saw chains are
designed to reduce the risk of kickback
injury. Other saw chains are designed to
achieve higher cutting performance or
sharpening ease, but in turn are more
prone to kickback.
STIHL has developed a color code
system to help you identify the STIHL
reduced kickback bars and low kickback
saw chains. Cutting attachments with
green warning labels on the packaging
are designed to reduce the risk of
kickback injury. The matching of green
marked or labeled chain saws under
3.8 cubic inches (62 cm³) displacement
with green labeled bars and green
labeled saw chains gives compliance
with the computed kickback angle
requirements of the chain saw standard
when the products are in their original
condition. Products with yellow labels
are for users with extraordinary cutting
MS 193 T
needs, having experience and
specialized training for dealing with
kickback.
STIHL recommends the use of its green
labeled reduced kickback bars, green
labeled low kickback saw chains and a
chain saw equipped with a STIHL
Quickstop chain brake for both
experienced and inexperienced chain
saw users.
Please ask your STIHL dealer to
properly match your chain saw with the
appropriate bar / saw chain combination
to reduce the risk of kickback injury.
Green labeled bars and saw chains are
recommended for all chain saws.
WARNING
Use of other, non-listed bar / saw chain
combinations may increase kickback
forces and the risk of kickback injury.
New bar / saw chain combinations may
be developed after publication of this
literature, which will, in combination with
certain chain saws, comply with the
chain saw standard as well. Check with
your STIHL dealer for such
combinations.
WARNING
Reduced kickback bars and low
kickback saw chains do not prevent
kickback, but they are designed to
reduce the risk of kickback injury. They
are available from your STIHL dealer.
WARNING
Even if your saw is equipped with a
Quickstop, a reduced kickback bar and /
or low kickback saw chain, this does not
eliminate the risk of injury by kickback.
Therefore, always observe all safety
precautions to avoid kickback situations.
Low Kickback Saw Chain
Some types of saw chains have
specially designed components to
reduce the force of nose contact
kickback. STIHL has developed low
kickback saw chain for your chain saw.
A "low kickback saw chain" is a saw
chain that has met the kickback
performance requirements of
ANSI/OPEI B175.1-2012 when tested
according to the provisions specified in
ANSI/OPEI B175.1-2012.
WARNING
There are potential chain saw and bar
combinations with which low kickback
saw chains can be used which have not
been specifically certified to comply with
the 45° computer derived kickback
angle of the chain saw standard. Some
low kickback saw chains have not been
tested with all chain saw and bar
combinations.
WARNING
A blunt or incorrectly sharpened saw
chain may reduce or negate the effects
of the design features intended to
reduce kickback energy. Improper
lowering or sharpening of the depth
gauges as well as changing the shape of
the cutters may increase the risk and the
energy of kickback. Always cut with a
properly sharpened saw chain.
English
17