Bleeding The Fl Uid For The Rear Brake - SHERCO X-RIDE 125 Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MAINTENANCE PROCESSES
Bleeding the rear brake fl uid
To bleed the rear brake system:
- Remove the fluid reservoir cap (see previous page).
- Remove the cover (1).
- Slightly loosen the bleeder-device (3).
- When you feel the handle reach the end of its travel, hold the
handle and then tighten the bleeder-device (3).
- Repeat various times until the air has been eliminated from the
fluid circuit.
- Refit the black protective cap (1).
- Refit the reservoir rubber and cap.
TIP
Place a cloth under the bleed nipple to absorb the fl uid.
WARNING
Brake fl uid is highly corrosive, therefore remove any spillage that may
have come into contact with parts of the motorbike.
45
owner's manual
X-RIDE 125/290
X-RIDE125/290
X-RIDE125/290
3
1
Rear brake bleed nipple
Rear brake pedal
2

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

X-ride 290

Tabla de contenido