Abus TVAC19100C Manual De Instrucciones página 18

English
You can configure the camera at settings.
Admin password
The Admin password must be entered to add the camera
and to go to the settings. The standard password is
"123456".
Change this at the initial installation to protect your camera
from unauthorised access.
If you have forgotten your password you can reset the
camera to the factory settings by pressing the reset button
for 5 seconds. The red LED starts to flash.
The camera must then be reinstalled.
Time zone
The world time zones are shown in the selection list.
Select the time zone in which the camera is installed.
Activate daylight saving if summertime applies to the world
time zone.
Daylight saving
Activate/deactivate daylight saving time.
Device security code
The standard security code is: 12345678
For reasons of security, change this code and enter a new
one (max. 8 digits).
Enter the code again to confirm.
Then confirm with "OK".
You will need the security code later if you want to access
the cameras via the app.
If you have forgotten your security code, you can reset the
camera to the factory settings by pressing the reset button
for 5 seconds.
The camera must then be reinstalled.
18