EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
IMPORTANT: KEEP
_
FOR FUTURE
REFERENCE
_ Read these instructions carefully.
Failure to follow them may put the
child's safety at risk.
_ The item is approved for children
aged 6-36 months and up to weight
of 15kg.
_ To make sure that any harness is
correctly fitted.
_ Do not leave the child unattended.
_ Do not use the high chair unless all
components are correctly fitted and
adjusted.
_ All assembly and operating
procedures should be performed by
an adult;
Not to use the high chair if any
part is broken, torn or missing.
_ Cleaning and maintenance must only
be carried out by an adult.
_ Take precautions to prevent the
child from falling or slipping out of
the product. Always use the 5-point
safety belt. Use the safety belt when
the child is lying down and sitting up.
_
Not to use the high chair until the child
can sit up unaided.
_ Tray and accessory trays are not designed
to support the child's weight; tray is not
designed to hold the child in the chair.
_ Always use the highchair on a flat,
horizontal surface.
_
To be aware of the risk of open fire and
other sources of strong heat, such as
electric bar fires, gas fires etc. in the
vicinity of the high chair.
_ Do not put fingers in the mechanism.
Make sure your child's arms and legs
are clear of the moving parts during
adjustment.
_ Using accessories that have not been
approved by the manufacturer may
be hazardous.
_ Do not use the product near stairs or
steps.
_ Be careful not to place the product
near sources of heat or flames, such
as gas stoves, electric heaters, etc.
INSTRUCTIONS
1 FITTING THE REAR WHEELS AND FRONT FEET: before
inserting the wheels, fit the wheel locks as shown in
the figure (fig_a). Fit the two wheels at the back of the
high chair (fig_b) and the two feet at the front (fig_c),
pushing in the direction of the arrow.
2 OPENING: when it is removed from the packaging,
the high chair is not in the correct position for use
(packing position). For use, raise it up until it engages
with a click at one of the seven chair heights (fig_a).
To open the high chair, push the red side levers down
(fig_b) and push the back supports outwards.
3 Before using the high chair, remove the spacers
(fig_a) and lower the footrest (fig_b).
4 TRAY: to fit the tray, pull the lever underneath it
towards you (fig_a) while at the same time inserting
it onto the armrests, and push down fully (fig_b). The
tray is extendible to three positions (fig_c). The third
position (indicated with red markings) should not be
used and is only for reclosing the tray.
_ To extend the tray, pull the lever under it and pull the
tray towards you into the first position, repeating the
operation to move it into the second position.
_ To remove the tray, pull the lever and at the same time
push the tray towards yourself until it disengages.
5 The high chair has a double tray. The top tray can easily
be washed in a dishwasher. To remove it, detach it from
the lower tray and lift it up (fig_a). To fix the tray on the
rear supports of the high chair, align and engage it with
the attachments provided (fig_b). When the high chair is
closed, the tray cannot be attached to the rear supports.
6 FIVE POINT SAFETY HARNESS: to close it, insert the two
waist strap buckles (with attached shoulder straps) into
the crotch strap until they click into position (fig_a). To
release it, press the two sides of the buckles and at the
same time pull the waist strap outwards (fig_b). To tighten
the waist strap pull from both sides in the direction of the
arrow (fig_c), to loosen do the opposite. The waist strap
can be tightened up to the safety stop (fig_d).
7 The shoulder straps can be adjusted to two different
heights. Unfasten the safety belt from behind the backrest
by pushing the buckle downwards (fig_a) and unthread
the strap from the cover (fig_b). Insert the strap buckle
into the other slot in the backrest (fig_c) and reattach the
buckle, pulling the strap until it clicks into position (fig_d).
8 ADJUSTING HEIGHT: the high chair can be set at 7 different
heights. To raise it, take hold below the tray and pull
upwards (fig_a). To lower it, press the two side buttons at
the same time and move to the required height (fig_b).
This can also be carried out with the child in the high chair.
9 RECLINING BACKREST. The high chair can be reclined
in four positions: for eating, playing, resting, or sleep.
To adjust it, raise the handle behind the backrest
(fig_a) and lock in the required position (fig_b). This
can also be carried out with the child in the high chair.
10 CLOSING AND REOPENING THE TRAY: to close the
tray, pull it to the third position indicated with the red
markings (fig_a), push down button 1 (fig_b), push
down button 2 (fig_c), and at the same time rotate
the tray upwards until it locks (fig_d). To reopen the
tray, push down button 2, rotate the tray downwards
and set it in the first or second position.
11 FOLDING: before folding up the high chair, close the
tray, move the backrest to the upright position, lower
the seat to the lowest position, and close the footrest.
To fold up the high chair, release the safety device by
turning it in the direction of the arrow and then press
the pedal (fig_a). At the same time take hold of the
seat and fold it by pulling it upwards (fig_b). The high
chair is freestanding when folded up.
- 10 -