Renegade RXA 1200D Manual De Uso página 11

HIGH GAINS & AUTO TURN ON
The high GAINs under HI INPUT (Fig. 6) is suitable to connect the device input with speaker wires, if your head
Then connect the each matching loudspeaker cable with the cables of the included High GAIN jack.
CAUTION: Never use the high GAINs and the RCA inputs at the same time. This may damage the device
seriously.
turn-on connection REM (Fig. 2,2) is not needed.
NOTE: The Auto Turn On function usually works with 90% of all head units, because they are equipped with
"High Power"-outputs. Only with a few older and head units the Auto Turn On function is not working.
INPUT SENSITIVITY
head unit to 80 - 90% of its full setting. Now turn GAIN clockwise until you hear some distortion. Then turn back
the GAIN slightly until you hear a cleaner sound.
VARIABLE SUBSONIC FILTER
frequencies to relieve the subwoofer or to generate a bandpass signal. If you don't want to use this function,
turn the controller (Fig. 1,5) to the very left to the 10 Hz position.
VARIABLE LOW PASS FILTER
Set the desired crossover frequency by using the controller LOW PASS (Fig. 1,4). Thus to that only the fre-
VARIABLE BASS BOOST
By using the BASS BOOST controller (Fig. 1,3) you are able to increase the bass enhancement from 0 to 12
dB. ATTENTION: Use the BASS BOOST wisely!
PHASE SHIFT CONTROLLER
The PHASE SHIFT controller (Fig. 1,6) allows to adjust the phase between 0° and 180° to match the output
signal with the vehicle's interior acoustic.
BASS LEVEL REMOTE CONTROLLER
With the included bass level cable remote controller you are able to adjust the bass level e.g. out of the driver's
seat. Connect the remote controller and the REMOTE connector (Fig. 1,2) with the enclosed cable.
11