Troubleshooting - Furrion 5 Vision S Manual De Instrucciones

Troubleshooting

Problem
Monitor won't turn on (no
blue LED)
Camera and Monitor won't
pair
Intermittent / Weak signal
icon appears
Night vision is poor or does
not function
Monitors Blue LED no light
with no picture
28
Check the power cable is connected.
Check the cigarette lighter has 12-24V DC Output.
Check the fuse in the cigarette socket adapter.
Check if the camera is receiving power.
Make sure to hold the camera pairing button for 2 seconds.
Check if the camera antenna is fitted and secured correctly - it should
be vertical.
Distance between camera and monitor is too great. Reduce distance
between Camera and Monitor.
Large dense objects could be obscuring the signal. If possible, move the
objects.
Interference from electrical appliances may be affecting the wireless
signal. Turn off the appliances when using the system.
Interference from overhead power lines may be affecting the signal.
Try unpairing and pairing.
The light sensor on the camera may be dirty or obstructed.
Ensure the camera unit is installed at least 2 inches away from rear
lights.
The camera has no power connected.
Ensure the tow vehicle is running.
Ensure the 7 way connector is connected.
Ensure that the circuit the camera is connected to has power and is
running.
Solution