Tabla de contenido
Publicidad
A06113901_rev1SanitaireProS5000A.qxp_Layout 1 8/24/18 9:57 AM Page 8
How to operate
ENGLISH
CAUTION
!
The upright vacuum cleaner is designed to
be used on multiple types of carpeting.
Do not attempt to use the cleaner with the
brushroll operating on bare floors, as
damage to the floor covering may result.
Power switch
• Plug electrical cord into outlet.
• Press down bottom of power switch ( I ) to turn ON.
Expect a short delay when turning the vacuum
cleaner on.
• Press down top of power switch (O) to turn OFF.
Suction control
• For deep pile carpet – including super plush –
adjust suction control as needed.
Handle adjustment
• Step on handle release pedal to lower handle into
desired position.
• The cleaner can lay completely flat for cleaning
under low furniture.
• Lower handle without stepping on handle release
pedal to raise the brushroll /nozzle over thresholds.
Vacuum cleaner height setting
Warning Avoid injury. Keep loose clothing, hair,
fingers, and all other parts of body away from any
moving part (such as the revolving brush). Turn
cleaner off and unplug before changing the height.
• Set height adjustment knob to lowest setting for
maximum cleaning. If cleaner is hard to push, turn
knob to next higher setting.
• The brushroll must reach the carpet for effective
cleaning.
Cleaning with tools
• Grasp wand handle grip to lift wand up and out of
channel. Push tool onto end of wand and stretch out
the hose.
• Dusting brush: use for furniture, drapes and vents.
• Crevice tool: use for corners, baseboards and
cushions.
• Upholstery tool: use for stairs and cushions.
• To use the hose without the wand, pull wand handle
from docked position. Push lever, and pull hose out
of wand. Attach desired tool.
• After cleaning, return tools to storage position and
place hose end back into wand.
8
www.sanitairecommercial.com
OFF (O)
ARRÊT (O)
APAGADO (O)
ON ( I )
MARCHE ( I )
ENCENDIDO ( I )
Publicidad
Tabla de contenido
