Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4
3
2
1
:
Slip the rope rotor (1) on to the
starter post and turn it back and
forth a little until the anchor loop of
the rewind spring engages
:
Fit the pawl (2) in the rope rotor
:
Place the washer (3) on the starter
post
:
Press the spring clip (4) on to the
starter post and over the pegs of the
pawl with a screwdriver or suitable
pliers. The spring clip must point to
the left, in anticlockwise direction
TS 410, TS 420
Tensioning the rewind spring
:
Make a loop in the unwound starter
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow
:
Hold the rope rotor tight: pull out the
twisted rope and untangle it
:
Release the rope rotor
:
Slowly let go of the rope so that it
winds on to the rotor. The starter
grip must be drawn firmly into the
rope guide bush. If it tips sideways:
increase the spring tension by
another turn
English / USA
:
It must be possible to turn the rope
rotor on another half-turn when the
rope has been drawn out
completely. If not, the spring has
been tensioned too tightly and may
break! Remove one turn of the rope
from the rotor
:
Refit the starter cover
:
Press the remaining rope into the
handle
Replacing a broken rewind spring
:
Remove the rope rotor as described
for "Replacing the starter rope"
The broken pieces of spring may
still be under tension and can spring
apart unexpectedly on removal from
the housing – injury hazard! Wear
facial protection and protective
gloves
:
Remove the spring housing and
spring parts
:
Apply a few drops of resin-free oil to
the new replacement spring
41
Publicidad
Capítulos
Tabla de contenido
