Trouble Shooting - IKEA AA-516805-6 Manual De Instrucciones

TROUBLE SHOOTING

Warning! Be sure to always turn the hand wheel towards you (counterclockwise). Turning it the other way may cause
damage to the needle or fabric, and you may be injured.
PROBLEM
The stitches form loops
The stitches shrink or
the fabric puckers
The fabric is not fed
evenly through the
machine
The sewing machine
is noisy and sews with
difficulty
The needle hits the
bobbin case and breaks
CAUSE
• The top thread has not been threaded through
the needle correctly.
• The bobbin thread has not been threaded into
the bobbin case correctly.
• The needle is too big for the fabric.
• Thread tension is too tight.
• The quality of the thread is not good enough.
• The bobbin thread has not been threaded into
the bobbin case correctly.
• You pull the fabric while sewing.
• There are traces of fluff and oil in the feed dogs
or needle holder.
• The needle is damaged.
• The retaining ring is not in the correct position,
and the levers are not locked.
• The bobbin case is not in the correct position.
• Forcing the fabric may cause the needle to bend
or break.
SOLUTION
• Thread the needle from the front to the back.
• Thread the bobbin thread into the bobbin case correctly (see
page 12).
• Use a smaller needle.
• Adjust the top thread tension (see page 24).
• Use a better thread.
• Thread the bobbin thread into the bobbin case correctly (see
page 12).
• Let the machine feed the fabric through
automatically.
• Clean the feed dogs and needle holder
(see page 25).
• Install a different needle.
• Install the retaining ring and bobbin case according to the
instructions (see page 26 and 27).
• Feed the fabric while sewing instead of forcing it.
ENGLISH
27