Led Indicators - GUTMANN Campo II 05 EM Instrucciones De Uso

Operation via Switch
Ceiling Device below the Pane)
Push one switch at the left side towards
symbol of fan:
Push longer than two seconds switch at the
left:
Push twice longer than two seconds switch
at the left:
The clean grease filter alert is operated by
this switch too. Push long until the red LED
is off.
Push left switch towards symbol of light:
Longer push results in dimmed light (not with
LED).
Push switch at the right side towards +
symbol:
performance
Push right switch towards – symbol:
lower fan performance
In certain cases switch allocation can differ
from the photo due to specific customer
requirements.
Button min. 10 sec. pressures
to a red LED
(Located on the
fan ON
after-run active
fan OFF
light ON/OFF
higher fan
goes off !

LED Indicators

(Located on the Ceiling Device)
Information regarding the operating
conditions of the hood can be read on the
device's LED indicators:
Indicators
LED 1: Indicates operational status ON/OFF
LED 1 blinking: Indicates automatic cool down
period (the hood will automatically decrease
by one power level every 5 minutes until it
finally turns off)
LED 2: Power level 1 (lowest motor speed),
press button 2 on the remote control once
LED 3: Power level 2 (middle motor speed)
Press button 2 on the remote control twice
LED 4: Power level 3 (high motor speed)
Press button 2 on the remote control three
times
LED 5: Intensive level (motor automatically
returns to level 3 after 3 minutes)
Press button 3 on the remote control
LED 6: Filter Saturation Indicator
The metal filter must be cleaned when the
red LED lights up (see section on cleaning
and care).
en