Pleasant Hearth OFW888R Manual De Instrucciones página 5

ASSEMBLY INSTRUCTIONS
1. Insert three of the M5x12 bolts (AA) through
the holes in the fire bowl (F) and into the three
holes in a leg (G). Position the leg as shown in
Step 1. Repeat this step for the three remaining
legs. Tighten securely with a screwdriver.
Hardware Used
AA
M5x12mm Bolt
2. Insert two M5x12mm bolts (AA) through the
mesh cover rest (D), through the holes in the side
of the fire bowl (F), and into the bracket holes of
the outer ring section (E). Make sure to insert the
male parts of the ring section (E) into the female
parts of the ring section (E). Loosely tighten by
hand. Repeat this step on two additional outer ring
sections (E). Assemble the final outer ring section
(E) without a mesh cover rest (D).
Hardware Used
AA M5x12mm Bolt
3. Turn the fire bowl (F) upside down. Insert
one ST5x15 bolt (BB) into the outer ring (E) and
tighten with a screwdriver. Repeat this step on
the remaining three connection points on the
outer ring (E). Once complete, tighten the bolts
from Step 2 with a screwdriver.
Hardware Used
BB ST5x15mm Bolt
1
x 12
2
E
x 8
3
BB
x 4
5
AA
F
G
F
AA
D
F
E