Makita XSR01 Manual De Instrucciones página 54

Ocultar thumbs Ver también para XSR01:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Table (A)
Molding
Bevel angle
position
52/38°
in the
type
figure
For
(a)
Left
inside
33.9°
corner
(b)
For
(c)
outside
(d)
corner
Table (B)
Molding
position in
the figure
For inside
(a)
corner
(b)
For outside
(c)
corner
(d)
Example:
In the case of cutting 52/38° type crown molding for
position (a) in the above figure:
Tilt and secure bevel angle setting to 33.9° LEFT.
Adjust and secure miter angle setting to 31.6°
RIGHT.
Lay crown molding with its broad back (hidden)
surface down on the turn base with its CEILING
CONTACT EDGE against the guide fence on the
saw.
The finished piece to be used will always be on
the LEFT side of the blade after the cut has been
made.
In the case of right bevel cut
(a) (b)
1. Inside corner 2. Outside corner
Miter angle
45° type
52/38°
type
Left 30°
Right
31.6°
Left
31.6°
Right
31.6°
Molding
Finished
edge against
piece
guide fence
Ceiling
Finished
contact edge
piece will be
should be
on the Left
against guide
side of blade.
fence.
Wall contact
edge should
Finished
be against
piece will be
guide fence.
on the Right
Ceiling
side of blade.
contact edge
should be
against guide
fence.
(c) (d)
1
2
Table (A)
Molding
position
45° type
Right
For
35.3°
inside
corner
Left
35.3°
For
outside
Right
corner
35.3°
Table (B)
For inside
corner
For outside
corner
Example:
In the case of cutting 52/38° type crown molding for
position (a) in the above figure:
Tilt and secure bevel angle setting to 33.9° RIGHT.
Adjust and secure miter angle setting to 31.6°
RIGHT.
Lay crown molding with its broad back (hidden)
surface down on the turn base with its WALL
CONTACT EDGE against the guide fence on the
saw.
The finished piece to be used will always be on
the RIGHT side of the blade after the cut has been
made.
26 ENGLISH
Bevel angle
52/38°
45° type
in the
type
figure
(a)
Right
Right
33.9°
30°
(b)
(c)
(d)
Molding
Molding
position in
edge against
the figure
guide fence
(a)
Wall contact
edge should
be against
guide fence.
(b)
Ceiling
contact edge
(c)
should be
against guide
fence.
(d)
Wall contact
edge should
be against
guide fence.
Miter angle
52/38°
45° type
type
Right
Right
31.6°
35.3°
Left
Left
31.6°
35.3°
Right
Right
31.6°
35.3°
Finished
piece
Finished
piece will be
on the Right
side of blade.
Finished
piece will be
on the Left
side of blade.

Publicidad

Tabla de contenido
loading

Tabla de contenido