Dc Power Port; Using The Usb Ports; Led Flashlight; Proper Disposal - Wagan Tech iOnBoost V8 Manual De Usuario

DC POWER PORT

For proper and safe operation of the DC power accessory outlet, do not place anything into it
except the plug of the accessory to be used.
Overloading the port may result in "tripping" a self-resetting circuit breaker. Removing the
overload automatically restores power to the DC Power Port.
1. Insert the DC connection cable into the DC output port (either 12V or 19V depending on
your device).
2. Select the appropriate connection head and attach to the other end of the cable.
3. Connect DC cable to the device you wish to charge.
4. Press the Power button to activate the power port.
5. After use, disconnect the DC connection cable.
6. Recharge the iOnBoost as soon as convenient.

USING THE USB PORTS

If the charge in the iOnBoost is low, the USB port will shut off to prevent damage to the iOnBoost.
Recharge the iOnBoost as soon as convenient.
1. Connect the USB device to the iOnBoost with either a user-supplied cable or the included
4-in-1 USB adapter.
2. Press the Power button to activate the USB ports.
3. When your mobile device is fully charged, disconnect your device from the iOnBoost.

LED FLASHLIGHT

If the charge in the iOnBoost is low, the light will shut off to prevent damage to the iOnBoost.
Recharge the iOnBoost as soon as convenient.
1. Hold down the Power button for 3 seconds to turn on the light.
2. Short press to cycle through the lighting modes: 1=strobe, 2=S.O.S., 3=off or long press to
turn off from any mode.
3. Recharge battery as soon as convenient.

PROPER DISPOSAL

• This product has no consumer serviceable parts.
• Do not attempt to remove or replace the battery used in this device. When
the battery has reached the end of its lifetime, please take the entire unit to a battery
recycling facility.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2016 Wagan Corporation. All Rights Reserved.
11