www.trapp.com.br
Warning!
All maintenance and cleaning should be
made with the equipment switched off and
the spark plug wire disconnected.
The air filter shall be always clean for the
engine to work perfectly.
Blocking of the filter due to lack of cleaning
causes serious operating problems for the
engine, among them loss of power, and
damage to the cylinder, piston and piston
rings.
9
5
4
4
2
2
3
Air Filter
Fixing the Handle to the Base
7
7
8
6
1
1
Air filter - foam
Dip and tighten (do not twist) it in a
solution of neutral detergent water,
removing all the dirt.
Dry it, rolling and pressing it in a dry
cloth (do not twist it).
Moisten the filter slightly with clean
oil (20W-50), always pressing it to
distribute the oil equally, removing
the excess.
Air filter - paper
Pass compressed air from inside to
outside the filter or knocking its base
lightly against a flat surface.
To fix the handle to the base, proceed as
follows:
Take the lower handle (1) and fit the hole (2)
to the support pin (3). Place the screw (4), the
washer (5) and tighten them with a butterfly
nut (6). After that, take the upper handle (7)
and place the screw (8).
Tighten it with the butterfly nut (9).
39