Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1
Cutting the opening
Af x template (B) to the countertop at the desired
location with cellophane tape.
Using a pencil, mark the guidelines on the countertop
following the template (B).
Drill a clearance hole approximately
inside the perimeter line of the template (B).
Cut the opening following the perimeter line of the
template (B).
NOTE:
To avoid possible damage to the cabinet,
cut the counter top before installing it to the cabinet.
3
Installing the sink
Apply caulking around the underside of the sink (A)
rim near the edge, as shown.
Carefully lower the sink (A) in place, aligning it, and
press rmly.
Wipe off the excess caulking.
2
1/4 in. to 1/2 in.
4
A
4
Positioning the sink
Check the cutout alignment by carefully positioning the
vessel sink (A) in the desired mounting poisiton.
Ensure the drain hole lines up with the cutout.
NOTE: It is recommended to practice the proper
insertion two or three times before applying sealant.
Installing the drain and plumbing
Install the drain (not provided) according to the manufacturer's
installation instructions.
CAUTION: Do not overtighten the drain assembly.
This may cause the bowl to forcefully crack during
installation or at some time in the future.
Install the waste system, faucet, and the water supply
(not provided) according to the manufacturer's installation
instructions.
Check for leakage.
A
Publicidad
