wilux HYDROCLEAN Manual De Instrucciones página 11

- if illuminated indicates presence of tension and
NOT enough water in the bathtub
- if not illuminated indicates presence of tension
and enough water in the bathtub
on/off water pump
cleaning cycle
Introduction
If the system is under tension the central led is illuminated. Fill the bathtub with warm
water (the ideal temperature is 37/38°C) approximately 10 cm. over the lateral jets. If
there is not enough water in the bathtub the central led will remain illuminated and it is
not possible to activate any function. Add extra water until the led will not be illuminated
anymore.
Function hydromassagepump
Press the key to activate the water pump. The pump functions only with enough
water in the bathtub. When the pump is functioning you can regulate the airflow towards
the jets; turn the operating knob to the right for more air and to the left for less air. To
deactivate the pump press again key
ATTENTION
BEFORE ACTIVATING THE DISINFECTION CYCLE ASSURE YOURSELF THAT
THERE IS ENOUGH DISINFECTION LIQUID IN THE TANK AND ENOUGH WATER IN
THE BATHTUB
Cleaning cycle
The cleaning cycle is completely automatic. Press the key
cleaning cycle (the led
in the bathtub. The blinking led indicates a lack of desinfection liquid, which has to be
integrated. The cleaning cycle is completed when the led
LED AND FUNCTIONS
.
will be illuminated), at this time there should not be any person
11
- if illuminated indicates cleaning cycle active
- if blinking indicates lacking desinfection liquid (it is
not possible to activate the cleaning cycle)
Operating knob: air regulation
for 3 seconds to start the
is not illuminated anymore.