E-V. Using The Hob - DERKOCH KAHLA Manual De Instalación Y Funcionamiento

Plantilla vitrocerámica

E-V. Using the hob

o The symbols on the Control Panel show which hotplate the control system
operates. A pilot light indicates when a hotplate is switched on.
o These hobs feature "touch control" and incorporate a safety lock system.
1. It is necessary to initially program the system by touching ON/OFF pad
(1) for 3 seconds. An audible "beep" will be emitted and the adjacent
neon will light. The desired cooking zone selection (2) can now be made,
however if a selection is not made within approximately 10 seconds the
hob will automatically switch OFF.
2. To switch on the cooking zone selected, touch the corresponding zone
identification pad and regulated by pressing either the decrease (4) or
increase (5) pad. The power level is indicated by LED symbols (6), 1 is
the minimum and 9 the maximum. An audible "beep" will be emitted at
each operation.
3. To switch OFF the cooking zone selected, press the decrease (4) pad until
all the LED symbols are extinguished (3). Alternatively, pressing the
ON/OFF (1) pad will shut down any cooking zone in use and turn off the
hob.
4. After use, the H symbol will remain lit in the corresponding zone
identification pad (3) to indicate residual heat. This will switch off when
the temperature drops below 50℃.
5. To prevent accidental use of a cooking zone, the key lock system can be
activated. Do so by pressing the KEY LOCK pad (9) once. An audible
"beep" will be emitted. The LED adjacent to the pad will illuminate
indicating that the lock is engaged. All cooking zones will be disabled and
any previous temperature settings will be maintained.
o These settings can be amended after disengaging the lock system,
making the required change and re-engaging the lock system.
o The lock system can be overridden by pressing the ON/OFF pad which
shut off the hob and cancel any temperature settings.
www.derkochline.com
Ceramic Hob
17