INFOSEC UPS SYSTEM E3 LIVE RT 2200VA Guía De Usuario página 29

Outlets do not provide
power to equipment
Fault
Fault code F06
Fault code F07
Fault code F08
Fault code F09
Fault code F11
Fault code F12
Fault code F13
Fault code F14
Fault code F15
Fault code F18
Fault code F19
Other
Software is inactive
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)240 94 29 51 - hotline@infosec.fr – 07 19 AA 36 205 10
The battery is worn out.
Mechanical problem.
Circuit breaker is tripped
due to overload
Batteries are discharged
Unit has been damaged
by a surge or spike.
INV soft start fail
INV volt high
INV Volt low
Output circuit short.
Battery voltage is too
high.
Battery voltage is too low
Battery is overcharge
Over load occurs.
load unbalance
Fan has been damaged.
Over temperature
The serial is not
connected.
Contact Technical Support.
Turn the UPS off and unplug at
least one piece connected
equipment. Unplug the power cord
of the UPS then press the circuit
breaker knob.
Allow the unit to recharge for at
least 4 hours.
Contact Technical Support.
Restart the UPS, if the fault is still,
contact Technical Support
Your attached equipment may have
problems, please remove them and
check again.
1. Shut down the UPS
2. Check the counts of Battery
3. Check battery connector when
use battery packages.
Shut off non-essential equipment.
If this solves the overload
problem, the UPS will transfer to
normal operation.
Shut down the UPS,Replace the
fan
1. Shut down the UPS. Restart the
UPS to Check the fan for
operation and if the ventilation
hole has been covered
2. Contact Technical Support.
Connect the serial cable to the
UPS unit and an open serial port
on the back of the computer. You
must use the cable that came with
the unit.
29