Before Starting The Equipment; Practical Tips - Toolson PRO-DS 200 E Manual De Instrucciones

Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level ........................ 73 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level .......................... 84 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
Handle
Vibration emission value a
K uncertainty = 1.5 m/s
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
Anl_PRO_DS_200_E_SPK7_Teil1.indb 14 Anl_PRO_DS_200_E_SPK7_Teil1.indb 14
= 8.9 m/s
2
h
2
- 14 -
GB
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
5.1 Fastening the grinding/sanding paper
(Fig. 2)
The Velcro fastener enables easy changing of
the grinding/sanding paper. Make sure that the
vacuum extraction holes on the grinding/sanding
paper and the grinding/sanding disk are aligned.
5.2 Installing the dust extractor adapter
(Fig. 3-4/Item 2)
Slip the dust extractor adapter (2) onto the vacu-
um cleaner connector (a) as shown in Fig. 3 and
lock it by twisting. Connect the dust extractor ad-
apter to a suitable dust extraction system.
6. Operation
6.1 Switching ON/OFF
Slide the switch (1) forwards to switch on the
equipment.

6.2 Practical tips

This equipment off ers particularly high perfor-
mance for the grinding/sanding of hard-to-reach
corners and edges. To grind/sand profi les and
channels you can also work with just the tip or
the edge of the grinding/sanding disk. Various
grinding/sanding papers are available, specially
designed for the diff erent types of material you
may be working on and the amount you wish to
remove from the surface. The amount removed
will depend largely on the choice of grinding/san-
ding paper and pressure applied to the grinding/
sanding disk.
26.02.14 17:17 26.02.14 17:17