Tritech T11 Manual Del Usuario página 42

Pressure Relief Procedure
accidentally.
Fluid under high pressure can be injected through skin and cause serious injury. To reduce risk of injury
from injection, splashing fluid, or moving parts,
Follow the Pressure Relief Procedure whenever you:
all or clean spray tip
Turn pressure control knob counterclockwise to stop.
2. Turn sprayer off.
3. Unplug power supply cord.
4. Hold metal part of gun firmly to grounded metal container. Trigger gun to relieve pressure.
5. Lock gun safety latch.
6. Open prime valve. Leave prime valve open until ready to spray again.
NOTE: Do not store unit for extended periods of time with the Pressure relief valve open. Store the unit
in the spray position.
NOTE: If suspected that spray tip or hose is completely clogged, or that pressure has not been fully
relieved after following steps above,
SLOWLY loosen tip guard or hose end coupling to relieve pressure gradually, and then loosen
completely. Clear tip or hose obstruction.
T9 UNITS ONLY
REPACKING PAINT/FILTER MANIFOLD
Follow pressure relief procedure before attempting to service or repair unit.
1. Remove suction set by unthreading nut item # 85, see frame and siphon tube then pull
downwards the inlet adaptor from intake housing # 20. Remove return hose #90 from
pump/filter manifold. Remove suction set from unit.
2. Remove filter bowl #1 and filter and spring support #3 and 4. Inspect and clean or replace filter
screen #3.
3. Remove intake valve housing #20.
4.
side of the intake valve housing and the piston guide. Gently pry upwards until piston guide is
free from intake valve housing.
PAINT/FILTER MANIFOLD SERVICE AND REPAIR
42