Tabla de contenido
Publicidad
CD3610
Preparation (continued)
Install Half-Sleeve
1.
Install adapter and dash kit if necessary (optional).
2.
Install half-sleeve into adapter or dashboard.
3.
Push tabs out to secure half-sleeve in the radio opening.
4.
Install support strap to make unit more stable.
Wiring
Wiring with a Wiring Adapter (Purchased Separately)
Connect Wires
You can make all these connections without even being in the car.
1.
Splice or crimp wires.
2.
Attach wiring adapter to car wiring harness.
Wiring Diagram / Color Codes
1.
Power Antenna (dark blue wire) - Connect to power antenna or amplifier. If not used, tape
bare end of wire.
2.
Ground (black wire) - Connect to ground terminal or clean, unpainted part of chassis.
3.
Memory/Battery (yellow wire) - Connect to battery or 12 volt power source that is always
alive. The radio will not work if this wire is not connected.
4.
Accessory/Ignition (red wire) - Connect to existing radio wire or radio fuse.
5.
Left front speaker
6.
Right front speaker
7.
Left rear spearker
8.
Right rear speaker
9.
RCA Outputs to Amplifier
10. Auxiliary Input Cables
11. Antenna
12. CD Changer
Fuses
When replacing a fuse, make sure the new fuse is the correct type and amperage. Using an
incorrect fuse could damage radio. The CD3610 uses one 15 amp fuse located below the
wiring connector: 15 amp fast blow ATO.
Reconnect Battery
When wiring is complete, reconnect the battery negative terminal.
Install Half-Sleeve
Instalación de la Camisa
Installation du demi-manchon
3
2
Wiring
Cableado
Câblage
10A
10
9
Rear
Gray
Posterior
Gris / Gris
Arrière
White/Black (-)
Gray/Black (-)
Blanco/Negro (-)
Gris / Negro (-)
Blanc/Noir (-)
Gris / Noir (-)
5
White / Blanco / Blanc (+)
Gray / Gris / Gris (+)
Violet/Black (-)
Green/Black (-)
Verde/Negro (-)
Violeta/Negro (-)
Vert/Noir (-)
Violet/Noir (-)
7
Green / Verde / Vert (+)
Violet / Violeta / Violet (+)
3
Connect Wires
Conecte los cables
Raccordement des fils
Jensen Connector
4
1
1
2
+
3
4
6
8
1
2
11
12
Publicidad
Tabla de contenido
