Troubleshooting - Danby DAC100B5WDB Manual Del Propietário

TROUBLESHOOTING

Danby Consumer Care: 1-800-263-2629 or consumerservice@danby.com
Hours of operation:
Monday to Thursday 8:30 am - 6:00 pm Eastern Standard Time
Friday 8:30 am - 4:00 pm Eastern Standard Time
Information in this manual is subject to change without notice.
PROBLEM
Appliance will not operate
Insuffi cient cooling
Noise
Odors
Water dripping inside
Water dripping outside
Frost build up
This Class B digital apparatus complies with the
Canadian ICES-003 standard. CAN ICES-3 (B)
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against interference in a residential installation.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation.
If this equipment does cause interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
• Plug is not fully inserted into the wall outlet
• Blown fuse or circuit breaker
• Air fi lter is dirty
• Blocked air fl ow
• Appliance size is too small for application
• Inadequate support in window installation
• Formation of mold or mildew on internal wet surfaces
• Place an algaecide tablet in base pan; push the tablet through
the grill on either side of the appliance
• Appliance is not properly angled to allow water to drain to the
outside
• On very hot or humid days dripping water from the back of the
appliance is normal
• When outdoor temperatures are below 18.3°C (65°F) frost may
form when the appliance is in cooling mode
• Switch the appliance to fan only mode until the frost melts
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment
and receiver.
3. Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
4. Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifi cations not approved by the
party responsible for FCC compliance could void
the user's authority to operate the equipment.
This appliance complies with Part 15 of the FCC
Rules.
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference
received, including interference that may cause
undesired operation.
13
POSSIBLE CAUSE