Makita XDT13 Manual De Instrucciones página 7

NOTE: If the driver bit is not inserted deep enough
into the sleeve, the sleeve will not return to its original
position and the driver bit will not be secured. In this
case, try re-inserting the bit according to the instruc-
tions above.
NOTE: When it is difficult to insert the driver bit, pull
the sleeve and insert it into the sleeve as far as it will
go.
NOTE: After inserting the driver bit, make sure that it
is firmly secured. If it comes out, do not use it.
Installing hook
2
3
► 1 . Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool. To install
the hook, insert it into a groove in the tool housing on
either side and then secure it with a screw. To remove,
loosen the screw and then take it out.
OPERATION
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between fas-
tening torque and fastening time is shown in the figures.
1
Proper fastening torque for standard bolt
N•m
(ft•lbs)
140
(103)
120
(89)
100
(74)
80
2
(59)
60
(44)
40
(30)
20
(15)
0
► 1 . Fastening time (second) 2. Fastening torque
Proper fastening torque for high tensile bolt
N•m
(ft•lbs)
200
(148)
180
(133)
160
(118)
140
(103)
120
(89)
2
100
(74)
80
(59)
60
(44)
40
(30)
20
(15)
0
► 1 . Fastening time (second) 2. Fastening torque
Hold the tool firmly and place the point of the driver bit
in the screw head. Apply forward pressure to the tool to
the extent that the bit will not slip off the screw and turn
the tool on to start operation.
7 ENGLISH
M16(5/8")
M16(5/8")
M14(9/16")
M12(1/2")
M14(9/16")
M10(3/8")
M12(1/2")
M8(5/16")
M10(3/8")
M8(5/16")
1.0 2.0
1
M14(9/16")
M14(9/16")
M12(1/2")
M10(3/8")
M12(1/2")
M8(5/16")
M10(3/8")
M8(5/16")
1.0 2.0 3.0
1